c-0202bizhub 250i

Konica Minolta bizhub 250i error C-0202: Tray failure

The Konica Minolta bizhub 250i error C-0202 specifically points to a lift motor failure in the paper tray. The system is unable to elevate the stack to the pick-up position. Why is my Konica Minolta bizhub 250i showing error C-0202 frequently? This is often due to an overloaded tray or a sensor obstruction within the tray cavity.

1 views

Common causes

  • 1Overloaded paper tray.
  • 2Lift sensor malfunction.
  • 3Mechanical gear block in the tray lift.
  • 4Worn feed rollers.

Solutions

Quick Diagnosis

If the tray does not move up or down as expected, the issue is mechanical or sensor-related.

Step-by-Step Solution

  1. Tray check: Remove the tray and check for paper scraps.
  2. Adjust guides: Re-align the paper guides to the correct size.
  3. Clear debris: Use compressed air around the lift assembly.
  4. Hard reset: Power cycle the copier.

Prevention and Maintenance

Do not exceed the designated paper fill level. Keep the tray area clear of dust.

When to Call a Technician

If the tray lift motor does not engage after rebooting, professional service for motor replacement is necessary.

Technical Specifications

  • Technology: Monochrome Laser
  • Speed: 25 ppm
  • Connectivity: Ethernet / USB
  • Capacity: 1,150 sheets
  • Compatible consumables: TN-328 Toner
  • Official drivers / firmware

Steps to follow

  1. 1

    Remove tray

    Pull the paper tray out of the printer.

  2. 2

    Clean sensors

    Wipe the lift sensor area with a dry, lint-free cloth.

  3. 3

    Reinsert tray

    Slide the tray back in until it is properly seated.

Frequently asked questions

This code indicates a failure in the tray lift motor.

Yes, you can configure the bypass tray for temporary use while the main tray is serviced.

Use original TN-328 toner for best machine health.

Ensure you don't overfill the paper tray.

Konica Minolta bizhub 250i error C-0202: Tray failure | Vimazdev