buffer-overflowDL7600

Fujitsu DL7600 error buffer overflow: Connection fix

The Fujitsu DL7600 error buffer overflow happens when the printer's internal memory fills up because data is sent faster than it can be printed. This message usually arises in high-demand environments or due to misconfigured port settings. Learning how to fix buffer saturation on Fujitsu DL7600 involves adjusting the flow control settings in the printer's driver. This robust dot matrix machine is highly reliable but sensitive to communication timing in older systems.

1 views

Common causes

  • 1PC sending data too rapidly for buffer speed.
  • 2Incorrect baud rate settings.
  • 3Low-quality data cables causing signal interference.
  • 4Excessive file complexity for printer memory.

Solutions

Quick Diagnostics

If the printer stops and displays memory-related warnings, check the handshake settings in your print queue configuration.

Step-by-Step Solution

  1. Clear queue: Cancel all pending print jobs.
  2. Restart: Cycle the power to clear the buffer RAM.
  3. Port config: Change flow control in the driver to Hardware or XON/XOFF.
  4. Driver update: Use the official driver to enable automatic flow control.

Prevention and Maintenance

Use high-quality shielded communication cables. Avoid sending graphics-heavy files that exceed the device memory. Keep the print head free of dust to maintain speed.

When to Call a Technician

If the error persists despite configuration changes, the internal memory board might be failing.

Device Technical Specifications

  • Technology: Dot matrix impact
  • Speed: High speed (up to 720 cps)
  • Connectivity: Parallel, Serial, USB
  • Compatible consumable: Original DL7600 ribbon
  • Maintenance: Routine ribbon replacement required
  • Official drivers / firmware

Frequently asked questions

It happens when the host computer sends data faster than the printer can process it.

No, it is a communication handshake issue that is easy to fix.

It uses DL7600 series ribbon cartridges.

Update your printer driver and set the handshake correctly.