b200PIXMA TS6320a

Canon PIXMA TS6320a error B200: Diagnostics & Steps

The Canon PIXMA TS6320a error B200 is a critical warning signaling a short circuit or voltage fault in the print head. This error is common when the equipment has exceeded its useful lifespan or has been subjected to voltage variations. Handling consumables carefully is essential to avoid electronic damage.

1 views

Common causes

  • 1Electrical failure in the print head.
  • 2Overheating due to low ink.
  • 3Corrosion on connection pins.
  • 4Unstable power source variations.

Solutions

Diagnóstico rápido

The B200 error halts the printer and requests a power-down. Check for burn marks or ink spills on the print head cradle.

Solución paso a paso

  1. Disconnect the power cable completely.
  2. Open the cover and remove the print head (if accessible) or just the ink cartridges.
  3. Inspect electrical contacts for dried ink or corrosion.
  4. Clean with isopropyl alcohol and wait for it to dry before reassembling.

Prevención y mantenimiento

Use voltage stabilizers. Do not force printing when ink levels are low. Quality of original CLI-281 cartridges is key for longevity.

Cuándo llamar a un técnico

If the error persists after contact cleaning, the logic board or the print head likely needs replacement.

Ficha técnica del equipo

  • Technology: FINE Inkjet
  • Functions: Multifunction printer
  • Connectivity: Wi-Fi, Bluetooth
  • Consumable: CLI-281 / PGI-280
  • Usage: Photography and documents
  • Official Drivers / firmware

Steps to follow

  1. 1

    Disconnect power

    Unplug the power cable for 10 minutes.

  2. 2

    Check cartridges

    Remove the cartridges and verify no ink is leaking.

  3. 3

    Safe restart

    Reconnect the unit and check if the warning disappears.

Frequently asked questions

It indicates a voltage surge or electrical failure detected in the print head.

Sometimes a power reset allows continued use, but it is a sign of print head degradation.

Use CLI-281 and PGI-280 series cartridges.

Use a voltage stabilizer and don't let ink levels drop to absolute zero.