b200pixma-ts5320

Canon PIXMA TS5320 Error B200: Print Head Fault

The Canon PIXMA TS5320 error B200 is one of the most critical issues users face. If you wonder what is the error B200 on Canon PIXMA, it is a fault in the print head's electrical circuit. This error requires immediate attention and typically signals a terminal failure of the print head.

1 views

Common causes

  • 1Short circuit in the print head due to ink leakage.
  • 2Voltage failure on the main logic board.
  • 3Extreme print head overheating from overuse.
  • 4Manufacturing defect in the head connector pins.

Solutions

Quick Diagnosis

Error B200 locks the printer entirely. It is a voltage fault detected by the logic board due to a short in the head matrix. Do not attempt to force printing.

Step-by-step solution

  1. Disconnect the power cable while the machine is on.
  2. Remove the ink cartridges and lift the head lock.
  3. Check for spilled ink on the back of the print head (contacts).
  4. Reconnect without cartridges to see if the error persists.
  5. If the error persists, the head has an irreparable electrical fault.

Prevention and maintenance

Never refill cartridges with low-quality ink that can leak and short the head. Keep the interior clean and free of particles that attract moisture. Using original Canon consumables is the best way to protect the head circuit against voltage spikes.

When to call a technician

B200 is almost always irreparable by the user. If the machine is under warranty, contact Canon support immediately.

Technical specifications

  • Technology: FINE inkjet
  • Speed: Up to 15 ipm
  • Compatible consumable: PG-260 / CL-261 cartridges
  • Recommended use: Domestic
  • Official drivers / firmware

Steps to follow

  1. 1

    Electrical reset

    Disconnect power for 10 minutes and remove ink cartridges.

  2. 2

    Head inspection

    Check for spilled ink on the print head connectors.

  3. 3

    Test run

    Turn on without cartridges to see if the error changes to 'cartridge not found'.

Frequently asked questions

It is a critical voltage error of the print head, usually caused by an electrical short circuit.

B200 usually indicates physical damage, making DIY repair limited to contact cleaning.

Often yes, as print head replacement is nearly as expensive as a new unit.

Always use original Canon inks; third-party inks often increase the risk of this short circuit.