900.00MX310dn
Lexmark MX310dn Error 900.00: System Fix
The Lexmark MX310dn error 900.00 is a generic system code signifying a crash in the controller card firmware. It often occurs due to memory overflow when processing complex documents. A cold reboot is the primary method to restore standard printer functionality.
1 views
Common causes
- 1Controller card firmware crash.
- 2Corrupt print job data.
- 3Sudden electrical fluctuation.
- 4Outdated device software.
Solutions
Diagnóstico rápido
The error appears on the main screen, freezing the printer's UI. It is likely triggered by a document that the controller cannot parse.Solución paso a paso
- Disconnect the power cord fully for 5 minutes.
- Delete all pending documents in the PC print queue.
- Disconnect all interface cables (USB/LAN).
- Power on the printer to check if the firmware boots.
Prevención y mantenimiento
Use a surge protector to guard the system board. Always keep your Lexmark printer firmware updated via official support channels.Cuándo llamar a un técnico
If the 900.00 error repeats every time the printer boots, the main logic board may be faulty and require replacement.Ficha técnica del equipo
- Technology: Monochrome multifunction laser printer.
- Speed: 35 ppm.
- Connectivity: USB, Ethernet.
- Capacity: 250-sheet input.
- Consumible: Lexmark 60F Series Toner.
- Use case: Small/Medium office.
- Official drivers / firmware
Steps to follow
- 1
Hard Power Cycle
Unplug the printer and leave it off for 5 minutes.
- 2
Clear Print Queue
Cancel all jobs pending on your computer.
- 3
Boot Up
Reconnect the power and turn the unit back on.
Frequently asked questions
Error 900.00 typically indicates a firmware or system board conflict during execution.
Often it is a temporary glitch, but it can indicate hardware fatigue if it persists after a reset.
It uses the Lexmark 60F series toner cartridges.
Regularly update the device firmware and ensure clean power delivery.