854imageCLASS D1650

Fix Canon imageCLASS D1650 Error 854 | Network Issues

Error 854 on the Canon imageCLASS D1650 indicates a failure to initialize or maintain a stable Local Area Network (LAN) connection. This occurs when the printer cannot obtain a valid IP address or experiences a handshake failure with the router. Switching to a static IP configuration is the most effective way to eliminate this error permanently.

1 views

Common causes

  • 1IP Conflict: Another device is attempting to use the same IP address.
  • 2Router failure: The DHCP server is failing to assign addresses.
  • 3Wireless interference: Physical obstructions or signal noise affecting Wi-Fi stability.
  • 4Damaged Ethernet cable: Broken wires or faulty connectors within the cabling.

Solutions

Diagnóstico rápido

If your office devices fail to send print jobs to the D1650, check the screen for error 854. This indicates the printer has lost communication with your router or network switch.

Solución paso a paso

  1. Power cycle the router and the printer to refresh the IP assignment table.
  2. Access the touchscreen, go to 'Network Settings', and select 'TCP/IP Settings'.
  3. Set a Static IP address instead of DHCP to prevent future conflicts with other network devices.
  4. Swap the Ethernet cable to a different switch port to rule out faulty hardware cabling.

Prevención y mantenimiento

Always assign a static IP outside of your router's DHCP range. Keep the printer firmware updated to ensure modern network protocol support and maintain a stable Wi-Fi environment without frequent SSID changes.

Cuándo llamar a un técnico

If the error persists after configuring a static IP and checking all cabling, the internal network interface card (NIC) might be faulty. Contact professional service for hardware verification.

Ficha técnica del equipo

  • Technology: Monochrome Laser
  • Speed: 40 ppm
  • Connectivity: Wi-Fi 802.11b/g/n, Ethernet (10/100/1000Base-T)
  • Input Capacity: 550 sheets
  • Compatible Consumables: Canon 121 (High Capacity)
  • Recommended Use: Corporate office networks
  • Official drivers / firmware

Steps to follow

  1. 1

    Refresh network

    Power cycle your router and printer for 30 seconds.

  2. 2

    Set Static IP

    Manually assign a fixed IP address in the printer's network settings.

  3. 3

    Test physical cabling

    Use a new Cat6 cable to eliminate hardware link errors.

  4. 4

    Print test page

    Print a network status report to confirm the new IP setup.

Frequently asked questions

It's not a hardware failure, but it blocks printing until the network link is re-established.

This printer uses the Canon 121 high-yield toner cartridge.

Assign a static IP to the printer so the router doesn't reassign its address to other computers.

Yes, switching to a local USB connection bypasses network errors entirely.

Fix Canon imageCLASS D1650 Error 854 | Network Issues | Vimazdev