701B4602

Error 701 OKI B4602: How to fix the fuser failure

The OKI B4602 error 701 is a warning signal indicating a critical failure in the device's fuser unit. This issue occurs when the fuser temperature fails to reach optimal levels, preventing proper toner fixation. To resolve this error 701 in B4602, you should perform a physical inspection of the thermal module and verify the device's electrical connection.

0 views

Common causes

  • 1Fuser lamp failure due to end-of-life.
  • 2Accumulation of paper residue obstructing the thermal sensor.
  • 3Electrical fluctuations affecting the internal power supply.
  • 4Natural wear of the fuser pressure rollers.

Solutions

Quick Diagnosis

Error 701 often appears as a flashing message on the panel. Check if the rear cover feels unusually hot or if the printer locks up immediately during warm-up.

Step-by-Step Solution

  1. Switch off the main power and wait 20 minutes for the fuser to cool down.
  2. Open the rear cover and remove any paper remnants that might block the path.
  3. Turn the unit on and hold the 'On-line' key to force a self-test.
  4. If the error persists, unplug the power cable for 5 minutes to clear the firmware cache.

Prevention and Maintenance

Perform regular cleaning of the fuser area using dry compressed air. Avoid using heavy-weight paper, as it accelerates thermal wear. Always use original consumables to prevent low-quality toner from damaging the fuser rollers.

When to Call a Technician

If the panel continues to display code 701 after resetting, it is likely the fuser lamp is burnt or the thermistor is damaged, requiring professional service.

Technical Specifications

  • Technology: Monochrome laser printer
  • Speed: Up to 40 ppm
  • Connectivity: USB 2.0 and Ethernet 10/100
  • Consumable: B4600 series (high-yield cartridge)
  • Recommended Use: Enterprise high-demand environments
  • Official drivers / firmware

Steps to follow

  1. 1

    Power off and cool

    Switch off the main power and wait 20 minutes for the fuser to cool down.

  2. 2

    Check for paper jams

    Open the rear cover and remove any paper remnants that might block the path.

  3. 3

    System reset

    Turn the unit on and hold the 'On-line' key to force a self-test.

Frequently asked questions

Error 701 usually indicates insufficient heating or a blocked sensor in the fuser unit.

Yes, it is a critical fuser failure that prevents proper printing and can damage paper.

This model uses the B4600/B4602 series supplies, preferably original cartridges for best results.

Cleaning every 10,000 pages or after a toner change is recommended to keep sensors dust-free.