60.02E360dn

Lexmark E360dn error 60.02: Fan failure

The Lexmark E360dn error 60.02 notifies that the cooling fan is failing. The fan is essential for pulling heat away from the fuser and main logic board. When it detects incorrect RPMs, the printer enters a standby error state to prevent serious thermal damage.

1 views

Common causes

  • 1Worn-out fan bearings.
  • 2Heavy dust buildup in the fan.
  • 3Disconnected fan power cable.
  • 4Faulty fan tachometer sensor.

Solutions

Quick Diagnosis

If the error 60.02 appears, your printer's fan might be seized or obstructed by dust. A ticking or grinding sound before the error often points to a mechanical failure in the fan bearings.

Step-by-Step Solution

  1. Check vents: Ensure no loose papers or dust accumulations are blocking any external cooling vents.
  2. Listen to fan: Pay attention during startup; if the fan doesn't whirl up, or you hear a struggling buzz, the fan motor is faulty.
  3. Dust removal: Use canned air through the ventilation grilles to remove dust buildup from the fan bearings.

Prevention and Maintenance

Regular maintenance is crucial. A semi-annual blow-out of the cooling path prevents dust from turning into a thick mat, which puts excessive strain on the fan motor.

When to Call a Technician

If cleaning doesn't revive the fan, it must be replaced. This is an internal task that should be handled by a certified Lexmark technician to prevent damage to the frame.

Equipment Specs

  • Technology: Mono Laser
  • Cooling: Forced air
  • Connectivity: USB, Ethernet
  • Compatible Consumable: Lexmark E360/460 series
  • Recommended Use: Enterprise/Small office
  • Official drivers / firmware

Steps to follow

  1. 1

    Check vents

    Ensure no paper or dust is blocking any of the external cooling vents.

  2. 2

    Listen to fan

    Check if the fan spins at power-up; if it is silent or clicking, the motor has likely failed.

  3. 3

    Dust removal

    Use canned air to blow dust out of the fan bearings.

Frequently asked questions

The printer has detected that the cooling fan is stuck or spinning at an incorrect speed, threatening the device's thermal safety.

No, printing without proper ventilation leads to rapid heat buildup, which can damage the toner and internal electronics.

It requires partial disassembly of the outer shell, so professional service is recommended.

Keeping the printer in a well-ventilated area and cleaning the air vents every six months prolongs fan motor life.

Lexmark E360dn error 60.02: Fan failure | Vimazdev