59.08.00pagewide xl 4200

HP PageWide XL 4200 error 59.08.00: Image motor fail

The hp pagewide xl 4200 error 59.08.00 is a hardware alarm indicating a failure in the main imaging motor. This code triggers when the controller detects an irregular load or synchronization issue. Professional intervention is often required. Proper ink usage and routine mechanical checks are essential for high-volume units.

1 views

Common causes

  • 1Motor torque overload during start-up.
  • 2Hall sensor error preventing RPM feedback.
  • 3Debris jammed in the ITB drive gears.
  • 4Internal bearing failure in the transport motor.

Solutions

Diagnóstico rápido

The 59.08.00 error causes the system to stop dead. If you hear rhythmic clicking before the error, check for mechanical friction inside the transport area.

Solución paso a paso

  1. Power cycle: Perform a full power drain to reset the logic board.
  2. Path inspection: Check for any stray scrap paper inside the unit.
  3. Component check: Verify all ink tanks are seated perfectly.
  4. Calibration: Start the printer; it should perform an automatic motor check.

Prevención y mantenimiento

Perform scheduled motor calibrations. Avoid using low-quality, heavy-weight paper that is not officially supported to prevent gear stress.

Cuándo llamar a un técnico

If the error persists after a full cold reset, the motor or the motor driver board has likely failed and requires a technician.

Ficha técnica del equipo

  • Technology: HP PageWide
  • Speed: Up to 42 ppm (D/A1)
  • Connectivity: Gigabit Ethernet
  • Capacity: 2-roll automatic feed
  • Compatible supplies: HP 841/842 Pigmented Ink
  • Best for: Large-format production
  • Drivers / official firmware

Steps to follow

  1. 1

    Power cycle

    Turn off the printer and unplug it from power for 5 minutes.

  2. 2

    Physical check

    Ensure there are no debris or jammed paper in the image transfer unit.

  3. 3

    Calibration

    Restart the device to initiate motor self-calibration.

Frequently asked questions

Error 59.08.00 is a critical motor error signaling that the system cannot track or drive the Image Transfer Belt (ITB) correctly.

Yes, it locks the system to prevent further physical damage to the motor assembly.

Always use genuine HP 841/842 pigmented inks to keep the print engine running smoothly.

Follow a strict maintenance schedule and perform regular mechanical calibrations.