5007PX45 RFID

Honeywell PX45 RFID error 5007: Ribbon Fix

The Honeywell PX45 RFID error 5007 is a ribbon-out notification. The device is unable to detect ribbon motion, which halts the printing process to prevent damage to the printhead. Follow these steps to verify your ribbon installation and clear the error notification efficiently.

0 views

Common causes

  • 1Empty ribbon core.
  • 2Ribbon not routed through the sensor.
  • 3Inadequate mechanical tension.
  • 4Accumulated dirt on the sensor optical path.

Solutions

Diagnóstico rápido

Confirm the ribbon isn't broken or finished. Ensure the ribbon passes through the light-path of the ribbon-end sensor.

Solución paso a paso

  1. Open the printer housing.
  2. Verify the ribbon spindle.
  3. Re-thread the ribbon through the sensor.
  4. Reset the status.

Prevención y mantenimiento

Maintain steady ribbon tension. Clean sensor paths if false errors occur.

Cuándo llamar a un técnico

If the ribbon path is clear but the error persists, the ribbon sensor could have failed.

Ficha técnica del equipo

  • Technology: Thermal Transfer.
  • Resolution: 203/300 dpi.
  • Connectivity: USB, Ethernet.
  • Consumable: Ribbon rolls (PX family).
  • Drivers / firmware official: https://www.honeywellaidc.com/support/px45-rfid

Steps to follow

  1. 1

    Check ribbon roll

    Inspect if the ribbon is depleted or not securely on the spindle.

  2. 2

    Route ribbon correctly

    Make sure the ribbon passes correctly through the sensor path.

  3. 3

    Clear error

    Press the reset/resume button on the control panel.

Frequently asked questions

This signifies a ribbon out status; check that your ribbon is installed.

It is a stop-print error requiring immediate consumable attention.

Use wax/resin ribbons suited for your specific media requirements.

Blow out dust from the ribbon path during every roll change.

Honeywell PX45 RFID error 5007: Ribbon Fix | Vimazdev