5004ZT411

Fixing Zebra ZT411 error 5004: Media Detection

The Zebra ZT411 error 5004 occurs when the media sensor cannot detect the beginning of the label, causing printing to stop. Resolve this by re-positioning the sensor and running the calibration routine.

0 views

Common causes

  • 1Misaligned sensor.
  • 2Adhesive buildup.
  • 3Gap too small.

Solutions

Quick Diagnosis

Check if the sensor is aligned with the label gap.

Step-by-step Solution

  1. Move Sensor: Adjust to label center.
  2. Calibrate: Perform media calibration.
  3. Check Mode: Ensure gap mode is set.

Maintenance

Clear adhesive from sensors.

When to Call a Technician

If error persists, sensor hardware might be failed.

Device Technical Sheet

Steps to follow

  1. 1

    Align

    Position sensor.

  2. 2

    Calibrate

    Run media calibration.

  3. 3

    Check

    Verify settings.

Frequently asked questions

Label gap not detected.

Usually just a cleaning issue.

Zebra series ZT.

Regular sensor dusting.

Fixing Zebra ZT411 error 5004: Media Detection | Vimazdev