4005PX45

Honeywell PX45 Error 4005: USB/LAN Communication Fault

The 4005 error code signifies a communication failure between the Honeywell PX45 and the host PC. It typically occurs due to IP conflicts, damaged USB cables, or misconfigured printer drivers.

1 views

Common causes

  • 1IP address conflict within the local network.
  • 2Faulty or underpowered USB port on the computer.
  • 3Outdated or corrupt printer driver.
  • 4Excessive USB cable length leading to signal degradation.

Solutions

Diagnóstico rápido

If the printer is unresponsive to print commands and shows '4005', check that the cable is firmly seated and that the printer isn't in 'offline' mode in your operating system.

Solución paso a paso

  1. Reset the connection by unplugging and replugging the USB/Ethernet cable.
  2. Check IP address (if on LAN) in the printer menu to ensure settings (Static/DHCP) are correct.
  3. Reinstall drivers using the latest official Honeywell driver from the support site.
  4. Swap cables to rule out physical damage to your connection hardware.

Prevención y mantenimiento

Use high-quality shielded USB cables no longer than 3 meters. If using a network connection, set a static IP address to avoid network collisions with other devices.

Cuándo llamar a un técnico

If replacing the cables and reinstalling drivers fails to make the device visible to the PC, the printer's communication board likely requires a hardware repair.

Ficha técnica del equipo

  • Technology: USB 2.0, Ethernet 10/100, Serial RS-232
  • Drivers: Windows, Linux and SAP-compatible
  • Firmware: Upgradable via USB/WEB
  • Compatible Consumables: PX-compatible industrial-grade thermal labels
  • Recommended Use: ERP and WMS system integration
  • Drivers / Official Firmware

Steps to follow

  1. 1

    Verify hardware

    Swap the data cable with a verified high-quality unit.

  2. 2

    Reset network

    Power cycle the device to force a DHCP renewal.

  3. 3

    Refresh Driver

    Clean install the official driver from the manufacturer's site.

  4. 4

    Ping Test

    Run a 'ping' command against the printer's IP address.

Frequently asked questions

Not necessarily. It is a communication error, usually fixed by checking cables or network settings.

Yes, if your workflow relies on continuous labels. Any downtime here directly affects operational output.

No. The consumables (labels or ribbon) are independent of data communication errors like 4005.

Assign a static IP outside of your main DHCP pool to ensure stability.

Honeywell PX45 Error 4005: USB/LAN Communication Fault | Vimazdev