400ES4192 Small Office

OKI ES4192 Small Office Error 400: Toner Issues

The OKI ES4192 Small Office error 400 appears when the printer fails to identify the toner cartridge. This is usually caused by poor contact between the toner's chip and the printer's internal sensors. A simple reseating of the cartridge often resolves the issue immediately.

1 views

Common causes

  • 1Dirty or oxidized chip contacts.
  • 2Improper toner insertion.
  • 3Defective chip in compatible toner cartridges.
  • 4Worn-out printer sensor contact pins.

Solutions

Diagnóstico rápido

If you see error 400, inspect the toner chip for debris or fingerprints. A dirty chip is the most frequent cause for this error message during normal operation.

Solución paso a paso

  1. Open the printer front access door.
  2. Pull out the toner and drum assembly.
  3. Clean the chip contacts gently using a soft, dry lint-free cloth.
  4. Reinsert the toner until you feel it click into position.

Prevención y mantenimiento

Handle your cartridges carefully, avoiding contact with the electronic chip. Using premium cartridges is recommended, as low-quality chips often fail to communicate correctly, triggering error 400.

Cuándo llamar a un técnico

If replacing the toner with a genuine cartridge does not remove the error 400, the printer's contact pins may be bent or broken, requiring professional repair.

Ficha técnica del equipo

  • Technology: Monochrome Laser Printer.
  • Speed/Performance: 40 ppm.
  • Connectivity: USB 2.0 / Ethernet.
  • Feed Capacity: 350 sheets.
  • Compatible Consumables: OKI Toner Series 45807106.
  • Recommended Use: Small Office.
  • Official Drivers / firmware

Steps to follow

  1. 1

    Open

    Access the front print unit.

  2. 2

    Reseat

    Remove and reinstall the toner cartridge.

  3. 3

    Check

    Verify if the status returns to ready.

Frequently asked questions

This error signifies that the printer cannot communicate with the toner chip or it isn't seated properly.

It is a minor mechanical/electronic fault that prevents printing until the toner is recognized.

Yes, it specifically refers to toner detection or chip connectivity.

Handle toner cartridges by the sides and ensure the chip area is free of debris.