33-print-head-errorE250dn

Lexmark E250dn error 33: Print head failure

The Lexmark E250dn error 33 is a technical alert indicating that the printer's laser print head has failed to initiate correctly. This usually implies that the laser motor is not reaching the necessary spin speed or the control logic has lost communication with the optical module. To address the Lexmark E250dn error 33, follow our diagnostic steps to determine if this is a temporary synchronization failure or a hardware component defect.

0 views

Common causes

  • 1Motor spin-up failure due to internal contamination.
  • 2Electronic board connection fault.
  • 3Wear and tear on the laser motor bearings.
  • 4Communication cable damage between print head and mainboard.

Solutions

Quick Diagnosis

If the printer displays '33 Print Head Error' during power-on and you hear a persistent whine from the engine, the internal laser unit is likely struggling to rotate.

Step-by-Step Solution

  1. Power off the device and disconnect the power cord.
  2. Open the access cover and take out the toner cartridge.
  3. Carefully inspect the interior for loose debris.
  4. Ensure the laser lens port is not blocked by excess toner dust.
  5. Reinsert the cartridge and perform a cold reboot.

Prevention and Maintenance

Avoid operating the printer in extremely dusty areas. Ensure you are using genuine Lexmark cartridges to minimize toner 'leakage' inside the printer casing.

When to Call a Technician

If the error 33 persists across multiple power cycles and cleanings, the laser scan unit motor or controller board has failed and requires replacement.

Device Specifications

  • Technology: Monochrome Laser
  • Print Head: Laser diode/motor unit
  • Connectivity: USB 2.0, Ethernet
  • Compatible Toner: Lexmark E250 / E350 series
  • Usage: Home/Small Office
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Power Cycle

    Switch off the printer and unplug it for one full minute.

  2. 2

    Toner inspection

    Remove the toner cartridge and clear any debris near the laser mirror area.

  3. 3

    Initialization test

    Power on and check if the printer completes startup without error 33.

Frequently asked questions

The error 33 indicates that the laser print head failed to sync properly during startup.

Yes, it is a critical error that prevents the printer from starting and printing.

The printer uses the Lexmark E250 / E350 series toner cartridges.

Keep the internal compartment clean and use genuine Lexmark toners to prevent dust buildup inside the optical path.

Lexmark E250dn error 33: Print head failure | Vimazdev