32.01B2650dw

Lexmark B2650dw Error 32.01: Output Jam

The Lexmark B2650dw error 32.01 is a warning that paper is caught in the output zone (near the fuser unit). The machine locks to prevent burning or further clogging. Knowing how to clear the Lexmark B2650dw error 32.01 is important, keeping in mind the high heat generated by the fuser area.

1 views

Common causes

  • 1Fuser Issue: Output rollers are not spinning.
  • 2Paper Creasing: Sheets folding before exiting.
  • 3Sticky Adhesive: Labels melting onto the fuser rollers.
  • 4Dirty Sensor: Toner dust clouding the exit sensor.

Solutions

Diagnóstico rápido

You will see the paper partially hanging out of the tray. Never yank on a stuck paper as it can tear and leave remnants inside the fuser.

Solución paso a paso

  1. Cool down: Wait 10 minutes for the fuser to lose heat.
  2. Open access: Open the rear or top tray to see the obstruction.
  3. Pull gently: Gently pull the sheet from both sides at once to avoid tearing.
  4. Check leftovers: Ensure no small scraps remain in the exit path.

Prevención y mantenimiento

Don't overfill the output tray. Ensure labels used are heat-resistant to prevent adhesive buildup on the fuser rolls.

Cuándo llamar a un técnico

If jams occur repeatedly in the output path, the exit rollers or fuser gears may be worn out and need replacement.

Ficha técnica del equipo

  • Technology: Monochrome Laser
  • Performance: 50 ppm
  • Connectivity: USB, Ethernet, Wi-Fi
  • Feed Capacity: 650 sheets
  • Compatible Consumables: B2650 Series Toner
  • Recommended Use: Professional Office
  • Official Drivers / firmware

Frequently asked questions

It means a sheet of paper is trapped near the fuser or the top output tray.

Be careful, the fuser area is very hot right after printing.

Not directly, but toner leakage can dirty the sensors, causing false readings.

Don't overload the output tray and remove documents frequently.

Lexmark B2650dw Error 32.01: Output Jam | Vimazdev