32-05M1145

Lexmark M1145 error 32.05: Technical Troubleshooting

The Lexmark M1145 error 32.05 indicates a communication failure between the printer and the smart chip embedded in the toner cartridge. This error is frequently encountered after installing a new supply or due to oxidation on the electronic pins. This guide will help you resolve the issue efficiently.

1 views

Common causes

  • 1Contaminated electronic contact pads.
  • 2Faulty chip on the third-party toner.
  • 3Incomplete physical installation of the cartridge.
  • 4Short circuit in the toner detection port.

Solutions

Diagnóstico rápido

If the error 32.05 persists, check if the cartridge is seated correctly. Dirty electronic pins are the most frequent culprit for this communication failure.

Solución paso a paso

  1. Remove cartridge: Open the door and pull out the toner assembly.
  2. Clean pins: Gently clean the contact pads on the cartridge with a lint-free cloth.
  3. Verify seating: Reinstall firmly.

Prevención y mantenimiento

Keep the printer internal cavity free from dust. Handle toner cartridges by the edges to avoid touching the sensitive chips. Use genuine cartridges for maximum reliability.

Cuándo llamar a un técnico

If the issue persists with multiple original cartridges, the printer's toner internal interface board may need replacement.

Ficha técnica del equipo

  • Technology: Monochrome Laser
  • Speed: Up to 45 ppm
  • Connectivity: USB and Ethernet
  • Resolution: Up to 1200 x 1200 dpi
  • Compatible supplies: Lexmark 24B series
  • Recommended use: Corporate environment
  • Drivers / firmware official

Steps to follow

  1. 1

    Open cover

    Open the front door to access the print cartridge.

  2. 2

    Clean contacts

    Remove the cartridge and wipe the gold electronic contacts with a dry cloth.

  3. 3

    Reinstall

    Push the cartridge back in until it locks into place.

Frequently asked questions

This code means the printer failed to communicate with the toner chip.

Third-party cartridges often trigger this error if the chip is not fully compliant with Lexmark firmware.

It uses the Lexmark 24B series toner cartridges.

If the error remains after testing a known-good original cartridge, the internal toner interface might be damaged.