2100pixma-ip110

Canon PIXMA iP110 Error 2100: Paper Size Mismatch

The Canon PIXMA iP110 error 2100 is a configuration notification indicating that the requested print size does not match the paper detected in the tray. Users encounter this when the printer fails to register the physical dimensions of the sheets. Why is my Canon PIXMA iP110 showing error 2100? It typically means your software settings and physical paper placement are out of sync.

1 views

Common causes

  • 1Tray paper guides not set to the correct physical size.
  • 2Mismatch between print software size and physical paper.
  • 3Use of non-standard paper or labels.
  • 4Obstruction of the optical paper size sensor.

Solutions

Diagnóstico rápido

Error 2100 is triggered if the paper stack is uneven or if you selected 'Legal' in your software but loaded 'Letter' paper. It is purely a mismatch issue.

Solución paso a paso

  1. Align: Set the paper guides snug against the edges of the stack.
  2. Software Config: Select the correct paper size in your print properties (e.g., A4, Letter).
  3. Validation: Hit the Resume/Cancel button if the message persists.

Prevención y mantenimiento

Always update the driver settings when changing paper types. Avoid overloading the tray or loading wrinkled sheets.

Cuándo llamar a un técnico

If the sensors consistently fail to identify standard paper, the optical sensor in the paper feed unit may require cleaning or replacement.

Ficha técnica del equipo

  • Technology: Portable Inkjet.
  • Supported Sizes: A4, Letter, Legal.
  • Capacity: Rear tray.
  • Consumibles: PGI-35, CLI-36.
  • Recommended Use: Traveling.
  • Drivers / official firmware

Steps to follow

  1. 1

    Verify Paper

    Ensure the paper guides are snug against the edges of the loaded paper.

  2. 2

    Adjust Settings

    In the print dialog, verify the paper size matches the actual paper in the tray.

  3. 3

    Resume

    Press the resume button on the printer to acknowledge the correct size.

Frequently asked questions

This error happens when the paper size settings from your computer don't match the paper detected by the printer's sensors.

You must adjust your document's page settings in your software or ensure the physical guides are positioned correctly.

Standard Letter or A4 paper. Very thick paper can sometimes obstruct the sensors.

Align the paper stack carefully against the guides to ensure the sensor reads the width correctly.