110.01mb2770adwhe
Lexmark MB2770adwhe Error 110.01: Fuser Jam
The Lexmark MB2770adwhe error 110.01 is a paper jam alert detected in the fuser area. When sheets do not exit correctly after the thermal fixation process, output sensors lock the machine to prevent further damage. Resolving the Lexmark MB2770adwhe error 110.01 requires careful manual extraction.
1 views
Common causes
- 1Paper jammed in fuser
- 2Dirty output rollers
- 3Non-spec paper usage
- 4Failed output sensor
Solutions
Diagnóstico rápido
If you see the 110.01 message, the printer has halted because the paper failed to reach the exit sensor after passing the fuser. This often happens if the paper is wrinkled or if there are adhesive deposits on the output rollers.Solución paso a paso
- Open rear cover: Open the rear door of the printer.
- Remove paper: Gently pull out the jammed sheet.
- Check fuser: Ensure no paper scraps remain.
- Restart: Close the door and let the printer initialize.
Prevención y mantenimiento
Always use well-aligned standard paper. Avoid using paper with adhesive (labels) that can peel off inside the fuser, damaging the equipment's lifespan.Cuándo llamar a un técnico
If you notice that the fuser rollers are worn or torn when removing the paper, it is time to replace the maintenance unit.Ficha técnica del equipo
- Technology: Monochrome laser printer
- Speed: 70 ppm
- Consumable compatible: Unison MB2770 series cartridges
- Connectivity: USB, Gigabit Ethernet
- Official drivers / firmware
Steps to follow
- 1
Open rear cover
Open the rear door of the printer.
- 2
Remove paper
Gently pull out the jammed sheet.
- 3
Check fuser
Ensure no paper scraps remain.
- 4
Restart
Close the door and let the printer initialize.
Frequently asked questions
This error indicates a paper jam located specifically in the fuser unit.
It is common when using paper that is too thick or contains staples.
Lexmark Unison MB2770 series toner.
Avoid high humidity to prevent paper sticking.