0x9EEcoTank Pro ET-16680

Epson EcoTank Pro ET-16680 error 0x9E: Ink fix

The Epson EcoTank Pro ET-16680 error 0x9E is an ink system warning indicating a pressure or flow inconsistency. When this appears, the printer blocks print tasks to prevent head damage. Why does my Epson EcoTank Pro ET-16680 show error 0x9E? Usually, this is due to low ink levels or trapped air in the ink tubes.

0 views

Common causes

  • 1Ink levels below the minimum threshold.
  • 2Air ingress into the ink supply tubes.
  • 3Optical sensor contamination on the tank.
  • 4Use of incompatible non-original ink.

Solutions

Diagnóstico rápido

The 0x9E code is often a sensor misreading caused by ink levels getting too low or air getting into the supply lines. Ensure the unit is on a flat, level surface and hasn't been tilted.

Solución paso a paso

  1. Ensure all ink tanks are filled above the minimum line.
  2. Run a "Printhead Cleaning" cycle via the settings menu to purge air.
  3. Verify the ink tanks are securely closed.
  4. Power cycle the printer to allow sensors to recalibrate.

Prevención y mantenimiento

Keep ink levels topped off. Using third-party inks often leads to sediment buildup that obscures the optical sensors, triggering the 0x9E error.

Cuándo llamar a un técnico

If you have performed multiple cleaning cycles and the error 0x9E persists, the internal ink pump or sensors may require professional repair.

Ficha técnica del equipo

  • Technology: PrecisionCore Heat-Free
  • Ink system: High-capacity refillable tanks
  • Yield: Up to 7,500 (BK) / 6,000 (CL) pages
  • Consumibles: 542 series ink bottles
  • Connectivity: Wi-Fi, Ethernet, USB
  • Drivers / official firmware

Steps to follow

  1. 1

    Check levels

    Ensure ink tanks are above the minimum fill line.

  2. 2

    Head cleaning

    Run a printhead cleaning cycle from the control panel to remove air bubbles.

  3. 3

    Restart system

    Power off and on to stabilize internal pressure sensors.

Frequently asked questions

Error 0x9E indicates a fault in ink flow readings or the rechargeable tank sensors.

No, it is a system error that prevents printing until cleared.

Use original 542 series ink for correct viscosity and density.

Keep levels topped up and perform maintenance cleanings periodically.