0x63expression premium xp-6105

Epson XP-6105 error 0x63: Paper Sensor Fault

The Epson Expression Premium XP-6105 error 0x63 is an alert indicating that the optical paper end or tray presence sensor has failed or is blocked. The internal scanner responsible for detecting if paper is loaded in the tray doesn't receive the correct reflection signal, causing the printer to lock to prevent printing blank pages. Often, this happens due to dust accumulation on the sensor.

1 views

Common causes

  • 1Optical paper sensor obstruction by dust.
  • 2Mechanical lever stuck with residue.
  • 3Failure of the emitter diode in the end-of-paper sensor.
  • 4Tray improperly inserted or misaligned.

Solutions

Quick Diagnosis

The 0x63 code usually appears after a paper jam where debris has remained in front of the optical presence sensor, tricking the system.

Step-by-step Solution

  1. Remove all paper from the loading tray.
  2. Use a flashlight to observe the bottom of the tray where the lever or optical sensor is located.
  3. If you see dust or paper scraps, use a small brush or dry air to gently clean the area.
  4. Restart the printer, ensuring you load the paper correctly into the tray.

Prevention and Maintenance

Avoid excessive dust in the feeding zone; keep the equipment covered when not in use. Ensure the tray is always clicked in properly when inserting it.

When to call a technician

If after cleaning the area the 0x63 error constantly persists, the optical sensor has an electrical fault and needs to be replaced.

Device Technical Sheet

  • Technology: Inkjet printer
  • Speed: Up to 32 ppm
  • Connectivity: Wi-Fi, USB
  • Compatible Consumables: Epson 202 cartridges
  • Recommended use: Photography / home
  • Official drivers / firmware

Steps to follow

  1. 1

    Inspect tray

    Remove the paper and clean the area where the tray sits.

  2. 2

    Clean sensors

    Use a soft brush to remove dust from the paper end sensor.

  3. 3

    Restart

    Power off, wait a few moments, and turn on again.

Frequently asked questions

The optical paper presence sensor doesn't detect paper or is obstructed.

It is a minor error that is corrected with external and internal cleaning.

Not a consumable, but paper type may affect sensor reflection.

Clean dust from the tray area each time you change the paper batch.