092-652Phaser 6600DN

Xerox Phaser 6600DN 092-652 Error: CTD Sensor

The Xerox Phaser 6600DN error 092-652 is a technical notification pointing to a failure in the Color Toner Density (CTD) sensor located near the transfer belt. This sensor is essential for the printer's automatic color adjustment, and when it fails to measure density, the device locks to avoid poor quality prints. Toner buildup is usually the primary cause of this fault. Xerox designed this series for high-performance environments where preventive maintenance is key.

1 views

Common causes

  • 1Residual toner obstructing the CTD sensor window.
  • 2Deterioration of the transfer belt surface.
  • 3Excessive toner accumulation due to leaking compatible cartridges.
  • 4Electronic sensor failure due to overheating.

Solutions

Diagnóstico rápido

The error appears on screen after a failed calibration attempt. If you see toner spots near the transfer belt, the diagnosis is confirmed.

Solución paso a paso

  1. Open cover: Open the front cover and carefully remove the Image Transfer Belt (ITB).
  2. Locate sensor: Locate the CTD (Color Toner Density) sensor located under the belt.
  3. Clean sensor: Use a dry cotton swab to remove toner dust from the sensor glass.
  4. Restart: Reinstall the ITB and close the covers, allowing the machine to recalibrate.

Prevención y mantenimiento

Avoid low-quality toners that are prone to leaking. Perform periodic cleaning of the ITB compartment whenever you replace consumables to avoid excessive accumulation.

Cuándo llamar a un técnico

If the error persists after careful cleaning, the CTD sensor may have failed electronically, or the transfer belt unit is faulty.

Ficha técnica del equipo

  • Tecnología: Color Laser
  • Velocidad/rendimiento aproximado: 36 ppm
  • Conectividad: Ethernet / USB
  • Capacidad de alimentación: 550 sheets
  • Consumible compatible: Xerox Phaser 6600 / WC 6605 cartridges
  • Uso recomendado: Departmental offices
  • Official drivers / firmware

Steps to follow

  1. 1

    Open cover

    Open the front cover and carefully remove the Image Transfer Belt (ITB).

  2. 2

    Locate sensor

    Locate the CTD (Color Toner Density) sensor located under the belt.

  3. 3

    Clean sensor

    Use a dry cotton swab to remove toner dust from the sensor glass.

  4. 4

    Restart

    Reinstall the ITB and close the covers, allowing the machine to recalibrate.

Frequently asked questions

This error occurs when the CTD sensor cannot correctly measure toner density on the transfer belt.

Yes, in most cases, toner dust accumulation is the culprit and a simple cleaning fixes the problem.

The Transfer Belt (ITB) and the cyan, magenta, yellow, and black toner cartridges.

If the error persists after physical cleaning, the sensor might be permanently damaged.