077-901Phaser 6600

Xerox Phaser 6600 error 077-901: Paper Feed Fix

The Xerox Phaser 6600 error 077-901 indicates a paper path interruption. This error is triggered when the printer's sensors fail to detect paper at the expected time, signaling a potential jam. This guide provides the necessary steps to safely locate and remove obstructions.

1 views

Common causes

  • 1Obstructed Path: Ripped paper remnants stuck in the feed path.
  • 2Dirty Sensors: Toner dust masking the optical sensors.
  • 3Worn Rollers: Friction components failing to pull the paper.
  • 4Poor Alignment: Paper loaded too tightly against the side guides.

Solutions

Diagnóstico rápido

This code usually points to a sensor being triggered because a piece of paper is stuck somewhere in the internal path. Even a tiny, torn edge can trick the sensor and prevent printing.

Solución paso a paso

  1. Tray Removal: Remove the paper tray completely.
  2. Manual Scan: Look for torn remnants inside the paper path using a flashlight.
  3. Sensor Cleaning: Use compressed air to blow out dust from the feed sensors.
  4. Reset: Reinsert the tray and ensure it is fully engaged before rebooting.

Prevención y mantenimiento

Don't overfill the paper tray beyond the line. Regularly clean the feed rollers with a soft, damp cloth and water. Use quality paper only, as cheap paper creates more dust.

Cuándo llamar a un técnico

If the error persists despite no paper being visible, the optical sensor itself might be damaged or disconnected.

Ficha técnica del equipo

  • Technology: Color Laser Printer.
  • Speed/Performance: 36 ppm.
  • Connectivity: USB, Ethernet.
  • Paper Capacity: 550 sheets.
  • Compatible Consumables: Xerox Phaser 6600 Toner.
  • Recommended Use: High-paced office environments.
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Check access doors

    Open printer doors and look for paper remnants.

  2. 2

    Clean sensors

    Use compressed air to clean optical sensor areas.

  3. 3

    Inspect tray

    Ensure the paper guides are not too tight.

Frequently asked questions

This code indicates a paper jam or a sensor timeout where paper is not detected in the feed path.

No, it usually involves identifying and removing the obstructed sheet carefully.

Yes, worn-out rollers can lead to feed failures; preventive maintenance is crucial.

Every 3 to 6 months to ensure proper paper traction and avoid future errors.