077-108D110

Xerox D110 Error 077-108: Output Jam Fix

The Xerox D110 error 077-108 indicates a paper jam located within the finishing or output area. When a document passes through the printer but fails to trigger the exit sensor at the correct time, the system triggers this protective error. Knowing why your Xerox D110 error 077-108 happens enables quick troubleshooting, allowing you to restore high-volume output functionality.

1 views

Common causes

  • 1Tray Capacity Exceeded: The finisher tray is full.
  • 2Skewed Media: Paper fed at an angle, causing a jam at the exit.
  • 3Damaged Finisher Rollers: Inability to move paper out properly.
  • 4Optical Obstruction: Torn paper bits blocking the exit sensor.

Solutions

Diagnóstico rápido

The 077-108 is detected when the exit sensor is blocked. Check if the output tray is overloaded, as this prevents the sensor from resetting properly.

Solución paso a paso

  1. Open Finisher: Open the finisher door according to the control panel prompt.
  2. Clear Jam: Carefully remove the sheet causing the obstruction.
  3. Secure: Close the door and wait for the printer to clear the state.
  4. Inspect: Check for any small scraps trapped in the finisher rollers.

Prevención y mantenimiento

Do not overload the output tray. Fan the media stack before loading to ensure every sheet feeds uniformly. Keeping the tray area clean of debris is essential for high-speed operation.

Cuándo llamar a un técnico

If the error persists after verifying the path is clear, an output sensor may have malfunctioned and requires professional technical support.

Ficha técnica del equipo

  • Technology: Monochrome Production Laser
  • Speed: Up to 110 ppm
  • Connectivity: Ethernet
  • Compatible Toner: Xerox D110 Series
  • Usage: Production printing
  • Drivers / Official Firmware

Steps to follow

  1. 1

    Open Finisher

    Access the finisher or output tray area using the indicated handles.

  2. 2

    Clear Jam

    Remove the jammed paper gently without tearing.

  3. 3

    Secure

    Close all doors to resume printing.

Frequently asked questions

It signals that an exit sensor failed to clear after a print job.

Yes, especially if the finisher tray reaches capacity.

Only use original Xerox D110 series toner.

Monitor tray levels and use flat, uncreased paper.