Xerox Phaser 7800 error 077-106: Paper Jam
The Xerox Phaser 7800 error 077-106 reports a paper registration issue within the print path. This error arises when the sensor fails to detect paper within the expected timeframe, usually due to jams or feed issues. Resolving the Xerox Phaser 7800 error 077-106 typically requires cleaning the sensors and checking for debris.
Common causes
- 1Poorly loaded paper (curled or damp).
- 2Worn feed rollers.
- 3Obstruction by label scraps or torn paper.
- 4Registration sensor contaminated with toner dust.
Solutions
Diagnóstico rápido
The error 077-106 often appears with a grinding motor noise or a failure to feed message. It is a classic physical maintenance issue involving paper friction.Solución paso a paso
- Open Trays: Open side covers to locate the registration path.
- Clear Jam: Carefully remove any paper or scraps.
- Verification: Ensure the registration sensor moves freely.
Prevención y mantenimiento
Clean feed rollers with a damp cloth monthly. Keep paper in low-humidity environments to prevent curling.Cuándo llamar a un técnico
If rollers are visibly worn or the error persists after thorough cleaning, contact a technician to replace the feed kit.Ficha técnica del equipo
- Technology: Laser Printer
- Feed Capacity: Up to 3140 sheets
- Supplies: 106R01570 Toner Series
- Recommended Use: Intensive production
- Official Drivers / firmware
Steps to follow
- 1
Open Trays
Open side covers to locate the paper registration path.
- 2
Clear Jam
Carefully remove any paper or scraps stuck near the registration sensor.
- 3
Verification
Ensure the sensor moves freely and is not blocked by dust.
Frequently asked questions
This error means the paper did not reach the registration sensor in time during the print cycle.
Yes, by using dry, ventilated paper before loading it into trays.
Worn-out feed rollers are the leading cause of this error.
If you pull too hard, you might damage sensors; always pull gently.