075-100Xerox Phaser 6510

Fix Xerox Phaser 6510 Error 075-100: Paper Tray Issue

Error code 075-100 on the Xerox Phaser 6510 indicates an issue with the paper feed system, typically related to size detection failures or a blocked sensor. This mechanical fault halts printing to prevent damage. Resolving it involves simple manual inspection and alignment of the paper tray.

1 views

Common causes

  • 1Misaligned paper guides triggering size detection errors.
  • 2Debris or torn paper stuck in the tray sensors.
  • 3Mismatch between software print job size and physical tray paper.

Solutions

Tray Inspection

  1. Remove the paper tray completely from the printer.
  2. Check for paper debris or remnants blocking the feed path.
  3. Ensure side guides are perfectly snug against the paper stack.

System Configuration

  1. Navigate to 'Settings' on the printer's display.
  2. Confirm the configured paper size matches the physical paper loaded.
  3. Select the correct 'Paper Type' (e.g., Plain, Cardstock) to match media.

Steps to follow

  1. 1

    Check Tray

    Pull out the tray and inspect for any paper obstructions.

  2. 2

    Adjust Guides

    Align sliding guides firmly against the edges of the paper.

  3. 3

    Verify

    Acknowledge the paper size prompt on the LCD control panel.

Frequently asked questions

It is triggered when the printer fails to detect or match the physical paper size in the tray.

Avoid overfilling the tray and ensure the paper is fanned properly before loading.

If the error occurs frequently, wiping the rollers with a clean, dry cloth is recommended.

Fix Xerox Phaser 6510 Error 075-100: Paper Tray Issue | Vimazdev