061-320B205

Xerox B205 Error 061-320: Troubleshooting Guide

The Xerox B205 error 061-320 indicates a thermal system failure in the printer's fuser unit. This error occurs when the fuser fails to reach the required operating temperature within the specified timeframe. Typically, a hard reset can solve the issue, allowing the printer to recalibrate. This laser multifunction device is known for its compact design and efficient networking capabilities.

1 views

Common causes

  • 1Fuser temperature sensor failure due to excessive heat buildup.
  • 2Paper jam blocking the roller movement, preventing heating.
  • 3Unstable electrical supply affecting the power board.
  • 4Natural hardware wear after extensive print cycles.

Solutions

Quick Diagnosis

The error 061-320 is displayed on the control panel. Verify if there is any unusual burning smell or excessive heat radiating from the back of the machine, which helps confirm a mechanical component failure.

Step-by-Step Solution

  1. Hard Power Off: Switch off the machine and unplug it from the power source.
  2. Cool Down Period: Allow the fuser unit to cool for at least 15 minutes before proceeding.
  3. Clear Debris: Open the rear access panel and ensure no paper fragments are stuck against the heat rollers.
  4. Wall Power: Plug the machine back directly into a wall outlet, bypassing any surge protectors or extensions.

Prevention and Maintenance

Clean the internal feed rollers annually. Do not exceed the supported paper weight (163 g/m²) and ensure the ventilation holes are kept free of dust for proper heat dissipation.

When to Call a Technician

If the 061-320 code continues to appear after following these steps, the fuser lamp or the thermistor might be physically damaged and require a professional replacement.

Ficha técnica del equipo

  • Technology: Monochrome Laser
  • Speed: 31 ppm
  • Connectivity: WiFi, USB 2.0, Ethernet
  • Feed Capacity: 250 sheets
  • Compatible Toner: Xerox 106R04347 / 106R04348
  • Recommended Use: Home office and small workgroups
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Power Cycle

    Turn off the printer and disconnect it from the wall outlet for at least 10 minutes.

  2. 2

    Check for obstructions

    Open the rear cover and look for paper remnants stuck near the fuser rollers.

  3. 3

    Reconnect

    Plug the device directly into a wall power source and power it on.

Frequently asked questions

This code signifies a fuser thermal error, often caused by a faulty temperature sensor or overheating.

Yes, it is a hardware-level error that prevents the printer from operating for safety reasons.

Always use original Xerox 106R series toner cartridges to ensure correct printer performance.

Ensure the printer is in a well-ventilated space and avoid printing on very thick media.