010-335VersaLink B7025

Error 010-335 Xerox VersaLink B7025: Fuser Failure

The Xerox VersaLink B7025 error 010-335 is a thermal alarm triggered by the fuser unit. This error indicates that the fuser assembly is failing to regulate temperature correctly, preventing the printer from bonding toner to the paper safely. Identifying the root cause quickly is essential to protect the printer hardware from extensive heat-related damage.

1 views

Common causes

  • 1Fuser unit heating element failure.
  • 2Over-temperature safety shutdown.
  • 3Paper blockage preventing proper heat dissipation.
  • 4Engine board failure to deliver power to the heater.

Solutions

Quick Diagnosis

If your Xerox VersaLink B7025 shows error 010-335, the system has detected a potential safety risk. The fuser's internal thermometer has tripped to prevent overheating, causing the printer to pause all operations immediately.

Step-by-Step Solution

  1. Cold Boot: Disconnect the printer power for 10 minutes to let the system cool down.
  2. Rear Inspection: Check for paper jams in the exit path that might lead to heat entrapment.
  3. Fuser Seating: Confirm the fuser module is locked firmly in position.

Prevention and Maintenance

Always use proper media types; heavy or glossy paper not suited for this printer can strain the fuser unit. Ensure the environment is well-ventilated to avoid heat accumulation around the fuser exhaust.

When to Call a Technician

If the 010-335 code persists after a hard power reset, the internal heating element has likely reached the end of its life cycle and requires a full replacement.

Device Technical Specifications

  • Technology: A3 Multi-Function Laser
  • Speed: 25 ppm
  • Connectivity: Ethernet, USB, NFC, optional Wi-Fi
  • Compatible Supplies: 006R01736 Toner series
  • Recommended Use: Corporate and departmental
  • Official Drivers / firmware

Steps to follow

  1. 1

    Cold boot

    Shut down the printer and unplug it for 10 minutes to reset the thermal sensors.

  2. 2

    Fuser inspection

    Check the rear unit for any stuck paper fragments that may interfere with heating.

  3. 3

    Check connections

    Ensure the fuser assembly is properly seated and the connector is clean.

Frequently asked questions

This code represents a fuser temperature issue, meaning it cannot maintain the correct heat required for toner bonding.

No, continuing to print may cause permanent damage to the fuser rollers.

Uses 006R01736 toner series.

General maintenance is recommended every 200,000 prints.

Error 010-335 Xerox VersaLink B7025: Fuser Failure | Vimazdev