010-332Baltoro HF Inkjet Press

Xerox Baltoro HF Inkjet Press error 010-332

The Xerox Baltoro HF Inkjet Press error 010-332 is a system code indicating a failure in regulating the thermal drying system. This alert is critical to productivity, as the equipment locks down to protect the paper transport if ink fails to dry properly. Knowing why my Xerox Baltoro HF Inkjet Press shows error 010-332 allows you to act quickly.

1 views

Common causes

  • 1Drying zone thermal sensor failure.
  • 2Burned-out drying heating lamps.
  • 3Non-certified paper retaining excessive moisture.
  • 4Blockage in the thermal module's ventilation.

Solutions

Quick Diagnosis

The error occurs when heat sensors do not confirm the proper temperature on paper within the expected time after printing.

Step-by-Step Solution

  1. Verification: Confirm no paper is jammed in the drying zone.
  2. Conditions: Check if the room meets environmental temperature specifications.
  3. Reset: Perform a restart of the press controller from the central console.
  4. Test: Run a printhead purge to verify flow.

Prevention and Maintenance

Maintenance must be strictly managed by certified personnel quarterly. Paper quality is vital: always use media certified for the Baltoro family to avoid absorption failures.

When to Call a Technician

If the code appears immediately after a system restart, the drying module is damaged and requires immediate technician intervention.

Device Technical Data

  • Technology: High-production Inkjet.
  • Speed: Up to 300 ipm.
  • Connectivity: 10Gbps Ethernet.
  • Compatible Consumable: Xerox Baltoro high-fidelity pigmented inks.
  • Recommended Use: Commercial production printing.
  • Official Drivers / firmware

Steps to follow

  1. 1

    Check Environment

    Verify print room temperature and humidity.

  2. 2

    Inspect Drying System

    Check if drying lamps are fully operational.

  3. 3

    Restart

    Reboot the print server to clear the error.

Frequently asked questions

It indicates a discrepancy in the ink drying system.

Not recommended, ink will be wet and will stain rollers.

Only use original Xerox Baltoro pigmented inks.

Quarterly preventive maintenance by a certified technician is required.