010-325AltaLink C8180
Xerox AltaLink C8180 error 010-325: Solution
The Xerox AltaLink C8180 error 010-325 is a fuser thermal failure notification. This code signifies that the heat sensor failed to report the necessary temperature increase during the initialization process. Fix error 010-325 on Xerox AltaLink devices by following the thermal reset steps below.
1 views
Common causes
- 1Fuser heating lamp failure.
- 2Sensor reading mismatch.
- 3Power supply voltage drop.
- 4Fuser assembly end-of-life.
Solutions
Quick Diagnosis
If the machine fails to heat up and reports 010-325, the internal heating circuit is likely failing. First, rule out any recent electrical supply changes.Step-by-Step Solution
- Turn the printer off completely using the main switch.
- Unplug the unit for 10 minutes to allow all circuits to reset.
- Check for any foreign objects that might block the heat sensors.
- Reconnect and power on.
Maintenance and Prevention
Ensure the printer is connected to a dedicated wall circuit. Overloading standard office circuits is a major cause of fuser thermal errors.When to Call a Technician
If the unit remains in error after a full reset, the internal thermostat is damaged. You need a certified technician to install a replacement fuser module.Printer Technical Specs
- Technology: Multifunction Laser
- Speed: 80 ppm
- Connectivity: Ethernet
- Consumables: AltaLink C81XX Toner
- Usage: Enterprise
- Official drivers / firmware
Steps to follow
- 1
Power off
Shut down the unit completely and unplug it.
- 2
Check for debris
Ensure there are no stuck papers in the exit path.
- 3
Reset
Plug the unit back in after 10 minutes and power up.
Frequently asked questions
The system cannot detect the fuser temperature reaching target levels.
No, it is a hardware safety feature that blocks printing.
Original Xerox AltaLink series toner ensures optimal fuser longevity.
Keep the area around the printer well-ventilated and free of dust.