010-323D136

Xerox D136 Error 010-323: Fuser Lamp Failure

The xerox d136 error 010-323 warns that the fuser heating lamp has stopped working. Without this heat, the toner cannot bond to paper. If you are learning what is 010-323 error on xerox d136, note that this indicates a hardware failure of the heating element within the fuser assembly.

1 views

Common causes

  • 1Blown heating lamp filament.
  • 2Disconnected fuser internal connector.
  • 3Relay failure on high voltage PCB.
  • 4Mechanical fuser lock-up.

Solutions

Quick Diagnosis

This error occurs if the system detects no temperature rise shortly after energizing the heating lamp, signaling a circuit break.

Step-by-Step Solution

  1. Turn the power off.
  2. Let the unit rest.
  3. Try to reboot once.
  4. Contact a service specialist if it fails again.

Prevention and Maintenance

Avoid rapid cycling of power. Proper power conditioning helps protect heating filaments.

When to Call a Technician

Every time this occurs, because the component is sealed inside the fuser housing.

Technical Specifications

  • Technology: Laser.
  • Speed: 136 ppm.
  • Consumable: Fuser module.
  • Usage: Production printing.
  • Support

Steps to follow

  1. 1

    Power Off

    Power off device immediately.

  2. 2

    Power Check

    Check electrical connection.

  3. 3

    Support

    Call for technician.

Frequently asked questions

This code means the halogen heater lamp inside the fuser unit has failed to ignite during the warm-up cycle.

No, the fuser unit must be replaced as a complete assembly.

Yes, printing is impossible without a functional fuser.

Ensure stable power supply for production machines.