005-281WorkCentre 5945i

Xerox WorkCentre 5945i error 005-281: Solution

The Xerox WorkCentre 5945i error 005-281 is an alert indicating a fault in the Automatic Document Feeder (ADF). This code appears when the paper path sensor does not receive the expected signal while processing documents through the scanner. It is generally caused by dirty rollers or paper residue trapped in the entrance.

1 views

Common causes

  • 1Paper debris or staples in the ADF input sensor area.
  • 2Wear of rubber feed rollers (loss of traction).
  • 3Dust buildup on the document path optical sensor.
  • 4Documents with sticky residue blocking thickness sensors.

Solutions

Quick Diagnosis

Error 005-281 activates when the feeder fails to pull the sheet or it stops halfway. If you hear a motor running but the paper doesn't move, check for labels stuck to the rubber rollers.

Step-by-step Solution

  1. Open top tray: Open the automatic document feeder (ADF) lid to view the entry path.
  2. Visual inspection: Remove any paper scraps, staples, or clips that might obstruct the feed rollers.
  3. Clean rollers: Clean feed rollers with a slightly damp cloth to remove accumulated dust.
  4. Cycle test: Insert a single sheet and perform a test scan to verify that the feeder works correctly.

Prevention and Maintenance

Avoid inserting documents with staples or clips, as these damage sensors and rubber rollers. Clean the traction rollers with a lint-free cloth at least once a month if used daily. Use original Xerox rollers to maintain the necessary traction.

When to Call a Technician

If the 005-281 code keeps appearing after cleaning the rollers and verifying there are no physical jams, a paper detection sensor might be faulty or the drive motor might be failing.

Ficha técnica del equipo

  • Technology: Multifunction Laser
  • Speed/Performance: 45 ppm
  • Connectivity: Ethernet, USB
  • Feed capacity: 4,700 sheets
  • Compatible consumable: Xerox 006R01603 Toner
  • Recommended use: High-volume office environments
  • Official drivers / firmware

Steps to follow

  1. 1

    Open top tray

    Open the automatic document feeder (ADF) lid to view the entry path.

  2. 2

    Visual inspection

    Remove any paper scraps, staples, or clips that might obstruct the feed rollers.

  3. 3

    Clean rollers

    Clean feed rollers with a slightly damp cloth to remove accumulated dust.

Frequently asked questions

005-281 indicates that the automatic feeder sensor did not detect paper advance correctly, usually due to a jam.

The main printer works, but you won't be able to scan via the automatic feeder until the error is cleared.

Check the feed roller status; the 5945i series has specific maintenance kits for the ADF.

Ensure documents are aligned and free of staples before inserting them into the feeder.