005-280WorkCentre 5945i

Xerox WorkCentre 5945i error 005-280 fix

The Xerox WorkCentre 5945i error 005-280 is an RADF scanner communication error, usually caused by document feeder jams or optical sensor obstructions. Cleaning the paper path typically solves the problem.

0 views

Common causes

  • 1Obstruction: Debris in the scanner path.
  • 2Dirt: Accumulation on entry sensors.
  • 3Roller wear: Lack of traction.
  • 4Faulty sensor: Internal hardware failure.

Solutions

Diagnóstico rápido

If the error appears without paper movement, it is a sensor blockage. If paper jams, it is a feed path issue.

Solución paso a paso

  1. Open the RADF cover.
  2. Remove any jammed documents.
  3. Wipe sensors with a clean, dry cloth.
  4. Close the cover and retry scanning.

Prevención y mantenimiento

Remove staples, clips, and tape. Regularly clean feeder rollers with distilled water.

Cuándo llamar a un técnico

If the error persists after thorough cleaning, the RADF sensor board or feed motor may be faulty.

Ficha técnica del equipo

  • Technology: Monochrome Laser MFP.
  • Speed: 45 ppm.
  • Connectivity: Ethernet, USB.
  • Compatible Consumables: RADF roller kits.
  • Use Case: Enterprise.
  • Drivers / firmware official

Steps to follow

  1. 1

    Open RADF

    Open the feeder cover.

  2. 2

    Clean sensors

    Wipe the optical sensors with a dry cloth.

  3. 3

    Reset

    Close and retry scanning.

Frequently asked questions

Indicates an automatic document feeder (RADF) sensor fault due to a jam or feed inconsistency.

Yes, feeder scanning is disabled.

RADF feed rollers.

Remove staples and clips before scanning.

Xerox WorkCentre 5945i error 005-280 fix | Vimazdev